4E-2 - ELECTRICAL KITS 90-823225--1 1096
If dashboard is vinyl covered, use a razor blade to re-
move vinyl from area to be drilled to keep vinyl from
tearing.
72807
b
a
Surface Mount - Single Engine
a - Wires Properly Routed
b - Self-Tapping Screw - Drill Pilot Holes Appropriate Drill Bit
Aluminum - 5/32 in. (4 mm)
Wood / Fiberglass 11/64 in. (4.5 mm)
72808
b
a
Flush Mount - Single Engine
a - Secure Mounting Screws With Nuts To Aid Installation
b - 2-1/8 in. (54 mm) Hole - Use Hole Saw
72809
a
Surface Mount - Dual Engines
a - Self-Tapping Screw - Drill Pilot Holes Appropriate Drill Bit
Aluminum - 5/32 in. (4 mm)
Wood / Fiberglass 11/64 in. (4.5 mm)
72810
a
Flush Mount - Dual Engines
a - 2-1/8 in. (54 mm) Hole - Use Hole Saw
IMPORTANT: Be sure to refer to appropriate wir-
ing diagram in the following step.
IMPORTANT: Lanyard stop switch being in-
stalled at second station (flybridge) must use Ex-
tension Harness Kit (84-16866A2) to connect
switch to wiring harness at main (lower) station.
Refer to instructions in extension harness kit.
3. Connect lanyard stop switch wires in accordance
with appropriate wiring diagram. Route switch
wires to prevent possible chafing or flexing during
boat operation. Secure wires with Sta-Straps.
To Next Page
Loading...
