Mercury 305 CID - Page 386

ELECTRICAL KITS - 4E-590-823225--1 1096
LANYARD STOP SWITCH WIRING DIAGRAM - SINGLE FUEL INJECTION ENGINE
Console Mount
Remote Control
d
e
f
g
h
i
J
k
k
n
o
m l
m
l
p
q
a
q
c
b
k
YEL/BLK
NOTE
NOTE
NOTE: Lanyard stop switch and neutral start leads must be soldered and covered with shrink tube for a water
proof connection. If alternate method of connection is made (use of electrical butt connector) verify connection
is secure and sealed for waterproof connection.
a - Lanyard Stop Switch (Use With Console Mount Remote Control)
b - Lead Not Used On 454 / 502 Multi-Port Injection
c - Lanyard Stop Switch Multi-Port / Throttle Body Injection Adapter Harness
d - Tachometer
e - Oil Pressure
f - Water Temperature
g - Battery Meter
h - To Engine Harness
i - Ignition Switch
j - Trim Indicator
k - Neutral Start Switch Leads
l - Trim Limit Switch Leads
m- Power Trim Harness Connector
n - Lanyard StopSwitch (Panel Mount Remote Control)
o - Trialer Switch (Console Mounted Remote Control)
p - Lanyard Stop Leads On Panel Mounted Control
q - Lanyard Stop Switch Multi-Port / Throttle Body Injection Adapter Harness (84-805745A2) Purchased Seperately