90-823225--1 1096 WEBER 4 BARREL CARBURETOR - 5D-17
5. Connect choke linkage rod and install retaining
clip.
71096
b
a
a - Clip
b - Linkage Rod
6. Refer to Section 2. Install and adjust throttle
cable following instructions appropriate to your
power package.
7. Install flame arrestor and tighten nut securely.
8. Reconnect battery cables to battery by first in-
stalling positive battery cable to positive (+) bat-
tery terminal. Tighten clamp securely. Then, in-
stall negative battery cable to negative (–) battery
terminal. Tighten clamp securely.
9. Turn on fuel supply at fuel tank.
10. Start engine and check for gasoline leaks. If leaks
exist, STOP ENGINE IMMEDIATELY and re-
check connections.
11. Adjust idle speed and idle mixture, as previously
outlined under “Adjustments.”
To Next Page
Loading...
