90-823225--1 1096 WEBER 4 BARREL CARBURETOR - 5D-27
IMPORTANT: If your carburetor had a ball and
weight combination, replace with ball and
weight. If your carburetor used a ball and spring
combination, replace with ball and spring.
70463
a
a - Ball Location
70464
b
c
a
a
a - Check Ball
b - Check Weight
c - Check Spring
28. Remove float bowl baffle plates, if necessary.
70465
a
a - Baffle Plate
IMPORTANT: Do not mix up the primary and sec-
ondary jets. Make note of the jet sizes and their
location before removal to be certain that during
reassembly they are installed in the carburetor
side from which they were removed.
NOTE: If jets are difficult to remove, place a screw-
driver, with the correct width, in the jet slot and lightly
tap the end of the screwdriver with a hammer.
29. Remove primary and secondary jets.
70466
b
a
a - Primary Fuel Jet
b - Secondary Fuel Jet
IMPORTANT: Before removing mixture screws,
check and note the number of turns from the fully
seated position. Also, do not mix up the two
screws.
To Next Page
Loading...
