ELECTRONIC FUEL INJECTION (MULTI-PORT AND THROTTLE BODY) - 5E-14390-823225--1 1096
INSTALLATION
1. Install rubber cushion and plate, making sure to
align cutout in plate with pump inlet.
2. Install screen on fuel pump.
3. Install adaptors, collar, plate and new O-ring on
fuel pump. Be sure that fuel pump relief valve fits
through hole in plate.
4. Slide fuel pump into cover.
5. Apply Loctite Type 8831 to threads of cover
screws. Install cover and electrical line retainer
clip and tighten cover screws securely.
6. Connect fuel pump electrical connectors. Snap
connector covers in place. Secure electrical line
in retainer clip.
7. Install L-joint onto cover. Tighten screw securely.
8. Connect all fuel lines to cover of vapor separator
tank. Torque fuel line fittings to 23 lb. ft. (31 N·m).
9. Connect fuel pump electrical connector.
10. With engine OFF, cycle ignition switch to ON, wait
2 seconds and then OFF, four times waiting 10
seconds after each key off to prime the fuel sys-
tem and check for leaks.
NOTE: If VST is dry, remove the vent screw and fill
with fuel.
Float and Needle Assembly
REMOVAL
1. Disconnect fuel pump electrical connector. (Elec-
tric fuel pump removed for visual clarity.)
72803
f
1
2
3
5
6
7
8
9
10
11
4
12
a
a
a - A VST equipped with elbow fitting on top of VST
will have this configuration diaphragm and
spring.
1 - Electrical Connector
2 - Cover
3 - Lockwashers (6)
4 - Screws (6)
5 - Clip
6 - Valve Seat
7 - Float Valve
8 - Float Valve Pin
9 - Clip
10- Float
11- Float Arm Pin
12- Screw
To Next Page
Loading...
