ELECTRONIC FUEL INJECTION (MULTI-PORT AND THROTTLE BODY) - 5E-17390-823225--1 1096
CLEANING AND INSPECTION
1. Clean knock sensor with a dry cloth, paying spe-
cial attention to threads on base.
2. Inspect surfaces of knock sensor for signs of
wear or physical damage.
INSTALLATION
IMPORTANT: If installing a new knock sensor, be
sure to replace it with an identical part. Knock
sensors are very sensitive and designed for each
specific application.
IMPORTANT: In the following step, it is very im-
portant that the knock sensor be torqued to the
precise specification. Incorrect torquing will re-
sult in unsatisfactory performance. DO NOT use
sealer on threads.
IMPORTANT: Ensure that the knock sensor is
installed in the upper location on the Y-fitting.
1. Install knock sensor in engine block. Torque to
12-16 lb. ft. (16.3-21.7 N·m).
73756
a
a - Knock Sensor
2. Connect electrical connector to knock sensor.
To Next Page
Loading...
