RISERS - 7C-190-823225--1 1096
Exhaust Riser (Kit)
Identification
IMPORTANT: All listed MCM and MIE Models can
be adapted to 9 inch (228 mm) exhaust risers by
stacking 3 inch (76 mm) riser kit (93320A7) and
the 6 inch (152 mm) riser kit (9322A4) with stain-
less steel elbows.
Torque Specifications
Fastener Location Lb. Ft. N·m
Exhaust Elbow
Exhaust Riser
Sealants
Description Part Number
Quicksilver Perfect Seal 92-34227-1
Replacement Information
Engine Preparation and Parts
Removal
!
WARNING
Avoid possible injury or damage to equipment
should wires be accidentally shorted. Discon-
nect BOTH battery cables from battery before
proceeding.
1. Disconnect battery cables from battery.
!
CAUTION
Avoid severe engine damage. Exhaust elbows
and manifolds MUST BE drained to prevent water
(or coolant) from entering combustion chambers
when exhaust elbows are removed.
2. Drain exhaust elbows and exhaust manifolds.
3. Remove any items attached to the elbows on the
engine and carefully lay them aside. Remember
their positioning for reassembly later.
4. Remove fasteners retaining exhaust elbows and
risers to manifolds and retain. Remove exhaust
elbows.
5. Remove and discard old gaskets. Clean gasket
mating surfaces on elbows, manifolds and risers.
To Next Page
Loading...
