HURTH DOWN ANGLE TRANSMISSION - 8C-2390-823225--1 1096
6. Remove tapered roller bearing, butting ring and
gear from piston end of shaft using special tool as
shown. Press all components off at the same
time. Then remove needle bearings.
27673
CLUTCH DISCS
NOTE: Discs on both sides of clutch are removed in
the same manner.
IMPORTANT: Reference marks are placed on the
clutch housing and end disc to aid in locating the
snap ring opening.
27675
a
a - Reference Marks
1. Position snap ring compression tool on clutch as-
sembly so that compression screws are centered
over slots in clutch housing.
2. Remove end disc and snap ring as follows:
a. Tighten all compression screws until a slight
resistance is felt.
b. Tighten compression screws evenly (approx-
imately 1/2 turn at a time).
c. Tap up lightly on bottom edge of compression
tool until snap ring pops up and out of groove
in clutch housing.
27674
b
c
a
a - Snap Ring Compression Tool
b - Compression Screws (6)
c - Slots
To Next Page
Loading...
