POWER STEERING - 9A-1190-823225--1 1096
INSTALLATION
!
CAUTION
Route hoses exactly as shown below. This will
help avoid stress on the hose fittings and will
help avoid kinks in the hoses.
IMPORTANT: Be careful to not cross-thread or
over-tighten hose fittings.
1. Thread large fitting into control valve. Position
hose properly (as prior to removal).
Earlier Style Control Valve: Torque large fitting to
20-25 lb. ft. (27-34 N·m).
72026
a
a - Large Fitting
Later Style Control Valve: Torque fittings to 23 lb. ft.
(31 N·m).
73786
2. Route hose along flywheel housing and secure
with J-clamp(s) provided.
3. Using hose clamp, install hose on fluid cooler.
Tighten clamp securely.
c
b
72588
a
Port Side Mounted Fluid Cooler
a - Fluid Cooler
b - Hose Clamp
c - Hose
74752
a
b
Rear Mounted Fluid Cooler
a - Fluid Cooler
b - Hose
4. Fill and air bleed system. Refer to Section 1B -
“Maintenance” (see “Table of Contents”).
To Next Page
Loading...
