5. To change the groove of an individual Sound, hold its pad (or hold SELECT + its pad if
pads are in Keyboard mode) and turn the 4-D encoder. In Keyboard mode you can also
press SELECT + the pad of the desired Sound, then hold any pad (i.e. any pitch of that
Sound) and turn the 4-D encoder.
6. Press CONTROL to leave Main mode and return to the default Control mode.
Press and turn the 4-D encoder to adjust the value in finer increments.
These shortcuts control the AMOUNT parameter in the SWING page of the Master’s, Group’s, and
Sound’s Groove properties, respectively. See section --- MISSING LINK --- for a detailed description
of these properties.
In the software you can also adjust the Swing amount of your Project via the SWING control in
the Header:
The SWING control in the software’s Header.
Tempo and Tune Shortcuts
1. Press MAIN to enter Main mode (the button must be lit).
2. Press F3 (TEMPO).
3. To change the tempo of the Master (i.e. the tempo of your Project), simply turn the 4-
D encoder.
4. To change the tune of all Sounds in a Group, hold the GROUP button, press the pad 9–16
of the desired Group (first navigate to its Group bank via the Left/Right Arrow buttons if
necessary), and turn the 4-D encoder while holding GROUP.
5. To change the tune of an individual Sound, hold its pad (or hold SELECT + its pad if pads
are in Keyboard mode) and turn the 4-D encoder. In Keyboard mode you can also press
SELECT + the pad of the desired Sound, then hold any pad (i.e. any pitch of that Sound)
and turn the 4-D encoder.
6. Press CONTROL to leave Main mode and return to the default Control mode.
Playing on the Controller
Playing Tools
MASCHINE MIKRO - Manual - 274
To Next Page
Loading...
Need help?
General
Weight and Dimensions
