Plug-in Menu Entry Description
Save As… Allows you to save the current Plug-in settings as a preset for
later use. This preset will appear in the Browser.
Save As Default… (only
when a Native Instruments
or External Plug-in is
loaded)
Allows you to save the current Plug-in settings as a default
preset. This default preset will be recalled each time you load
the Plug-in from the Plug-in menu.
Note that the first two submenus Native Instruments and External only show the Plug-ins that are
enabled in the Plug-ins page of the Preferences panel. For more on this, see section ↑3.6.6, Prefer-
ences – Plug-ins Page.
The edit commands (Cut, Copy, and Paste) and preset management commands (Open, Save As…,
and Save As Default…) available at the bottom of the Plug-in menu will be covered in section
↑7.1.7, Moving Plug-ins and ↑7.1.9, Saving and Recalling Plug-in Presets, respectively.
7.1.3.1 Loading, Removing, and Replacing a Plug-in on your Controller
On the MASCHINE MIKRO controller, do the following:
1. Press CONTROL to enter Control mode.
2. Select the Sound, Group or the Master where you want to load, remove or replace a Plug-
in (see section ↑3.3.4, Focusing on a Group or a Sound).
3. Press NAV + F3 (PLUG-IN) to display the Plug-in slots of the selected Sound, Group or
the Master.
4. While holding NAV, turn the Control encoder or press the dimmed pads to select the de-
sired Plug-in slot.
The name of the selected Plug-in appears in the display — if there are no Plug-ins in the
channel this will read (NONE).
→ You are now ready to load, insert, remove or replace a Plug-in as described in the follow-
ing paragraphs.
Working with Plug-ins
Plug-in Overview
MASCHINE MIKRO - Manual - 310
To Next Page
Loading...
