Once an Audio Plug-in is loaded it becomes visible in both the MASCHINE software and on the
controller.
MASCHINE Audio Plug-in
Here is an overview of the Audio Plug-in parameters:
Element Description
PLAYBACK Section
Mode Select the mode of playback: Loop or Gate.
Loop: The default mode for playback, in this mode the Sample is
heard with the Pattern (as with any regular MIDI event) without the
need to trigger it. In this mode, Playback and Source parameters can
be manipulated such as Tune, Pitchbend, Tempo, and Length.
Gate: When Gate mode is selected the Sample is only heard when
triggered by a MIDI note event. The Sample is heard for the duration
of the MIDI note event, and the note can also be used to pitch the
Sample for melodic effect.
Fade (Gate mode only) Set a simple fade-in/fade-out amount to avoid pops or clicks that may
occur when using the Gate mode. To increase the fade of Gate mode,
turn the Fade knob clockwise by clicking and dragging upwards. To
decrease the fade, turn the Fade knob counter-clockwise by clicking
and dragging downwards. Press the [SHIFT] key on your computer
keyboard while turning the knob to increase or decrease the fade in
finer increments.
Using the Audio Plug-in
MASCHINE MIKRO - Manual - 348
To Next Page
Loading...
Need help?
General
Weight and Dimensions
