As soon as some modulation is recorded for a parameter in a particular Pattern of the Group,
the corresponding Modulator and modulation track appear for all Patterns of the Group. The
track will be empty for Patterns in which you haven’t recorded any modulation for this parame-
ter yet. Similarly, if you delete this Modulator in the Modulator List and its modulation track
(see below to know how) in a Pattern, it will be deleted in all other Patterns of the Group as well.
Editing Modulation Points
You can create, edit, and delete modulation points in the displayed modulation track with your
mouse. As for the Event area above, the mouse behavior in the Control Lane will depend on the
Mouse Edit mode selected in the Edit Mode selector, at the bottom left of the Pattern Editor:
The Edit Mode selector.
All actions in the Control Lane are quantized according to the Step Grid. For more information
on the Step Grid, please refer to section ↑11.1.7, Adjusting the Step Grid and the Nudge Grid.
Working with Patterns
Recording and Editing Modulation
MASCHINE MIKRO - Manual - 508
To Next Page
Loading...
