Selecting a Pattern
► To select a Pattern in the current Pattern bank, press PATTERN + the dim lit pad corre-
sponding to this Pattern.
→ When a Pattern is selected:
▪ This Pattern is displayed in the software’s Pattern Editor. You can then modify it both from
your controller and in the software.
▪ This Pattern is referenced for the selected Group in the current Scene. This Pattern repla-
ces any previous Pattern selected for the Group in that Scene (see chapter ↑16.3, Using
Song View for more on this).
Selecting Patterns and Pattern Banks on the Controller
Selecting a Pattern Bank
To select a Pattern located in another Pattern bank than the one selected, you first need to
select that other Pattern bank:
1. Press and hold PATTERN to enter Pattern mode.
2. Press SHIFT + Left/Right Arrow button to select the previous/next Pattern bank, respec-
tively.
If the last Pattern bank is selected and not empty, pressing SHIFT + Right Arrow button will create
a new, empty Pattern bank — see section ↑11.7.5, Creating and Deleting Pattern Banks for more
information.
Selecting a Pattern
► To select a Pattern in the current Pattern bank, press PATTERN + the dim lit pad corre-
sponding to this Pattern.
→ Selecting a Pattern has the following consequences:
▪ This Pattern is displayed in the software’s Pattern Editor. You can then modify it both from
your controller and in the software.
Working with Patterns
Managing Patterns
MASCHINE MIKRO - Manual - 518
To Next Page
Loading...
