2. To adjust the Perform Grid, click the Performance Grid menu in the Header and select the
desired division from the menu:
→ The next time you select a new Scene/Section or group of Scenes/Sections for looping, the
switch will happen on the next division selected here.
► To enable/disable the Retrigger setting, click the Performance Grid menu in the Header
and select Retrigger from the menu.
→ The next time you select a new Scene/Section or group of Scenes/Sections for looping, the
new loop will start from the beginning of the first Scene/Section (Retrigger enabled) or
from the same position as where it left the current Scene/Section (Retrigger disabled).
Working with the Arranger
Arranger Basics
MASCHINE MIKRO - Manual - 762
To Next Page
Loading...
