3. Select the desired Section by clicking the slot with its name in the list on the left or by
clicking its cell in the selected pad grid on the right.
→ The Section slot and the corresponding cell on the right are now highlighted to indicate
that this Section is selected.
Once a Section Has Been Selected…
Once you have selected a Section using either of the methods described above, the following
happens:
â–ª The Pattern Editor displays the Pattern corresponding to the focused Group in this Section.
If there is no Pattern for the focused Group in the Section you have just selected, the Pat-
tern Editor is empty.
â–ª Additionally, if the selected Section is outside the current Loop Range:
â—¦ The Loop Range is set to the selected Section.
â—¦ If playback is off the playhead immediately jumps to the beginning of the selected
Section. If playback is on the playhead jumps according to the Perform Grid settings.
For more info on the Loop Range see section ↑16.3.1, Section Management Overview. For more info
on the Perform Grid settings see section ↑16.3.1, Section Management Overview.
Working with the Arranger
Using Song View
MASCHINE MIKRO - Manual - 787
To Next Page
Loading...
Need help?
General
Weight and Dimensions
