Selecting Sections and Section Banks on the Controller
Selecting a Section Bank
To select a Section located in another Section bank:
1. Press SHIFT + SCENE to enter Song view.
2. Press and hold SCENE to enter Scene mode (or pin it by pressing SCENE + MAIN).
3. Press SHIFT + Left/Right Arrow button to select the previous/next Section bank, respec-
tively.
If the last Section bank is selected and not empty, pressing SHIFT + Right Arrow button will create
a new, empty Section bank, see section ↑16.3.12, Creating and Deleting Section Banks for more
info.
Selecting a Section
â–º To select a Section in the current Section bank, press SCENE + the dim lit pad corre-
sponding to this Section.
Upon your selection, the following happens:
â–ª The Pattern Editor displays the Pattern for the focused Group in this Section. If there is no
Pattern for the focused Group in the Section you have just selected, the Pattern Editor is
empty.
â–ª The Loop Range is set to the selected Section, see section Selecting a Loop Range.
â–ª If playback is off the playhead immediately jumps to the beginning of the selected Section.
If playback is on the playhead jumps according to the Perform Grid settings, see section
Jumping to Other Scenes.
Selecting Sections and Section Banks on the Controller
Selecting a Section Bank
To select a Section located in another Section bank:
1. Press SHIFT + SCENE to enter Song view.
2. Press and hold SCENE to enter Scene mode (or pin it by pressing SCENE + CONTROL).
Working with the Arranger
Using Song View
MASCHINE MIKRO - Manual - 788
To Next Page
Loading...
Need help?
General
Weight and Dimensions
