]
Adjusting the source and mode of the recording on your controller.
1. To select the parameters described below press the Left/Right Arrow button.
2. To adjust the selected parameter, turn the Control encoder. For continuous parameters,
press and turn the Control encoder to adjust the value in finer increments.
Selecting the Source to Record
First choose which source you want to record using the SOURCE and INPUT parameters:
Parameter
Description
SOURCE Select the type of source you want to record.
To record external audio signals connected to your audio interface,
select EXT. STER. (for stereo signals) or EXT. MONO (for mono
signals).
To record audio signals coming from MASCHINE itself, select
INTERNAL.
INPUT Choose between the available inputs. The available inputs depend on
the SOURCE setting (see above).
If SOURCE is set to EXT. STER. you can select from the four external
stereo inputs IN 1–4 available in MASCHINE.
If SOURCE is set to EXT. MONO you can select either of
MASCHINE’s eight external mono inputs: the left (“L”) or right (“R”)
channel of each input pair IN 1–4.
If SOURCE is set to INTERNAL you can select the output of any
available Group or the Master.
Sampling and Sample Mapping
Recording Audio
MASCHINE MIKRO - Manual - 822
To Next Page
Loading...
Need help?
General
Weight and Dimensions
