17.2.4 Arming, Starting, and Stopping the Recording on Your Controller
Starting and stopping the recording.
â–º Press F1 (START) to arm the recording.
After the recording has been armed, its behavior will depend on the recording mode you have
selected (via the MODE selector, see section ↑17.2.2, Selecting the Source and the Recording
Mode above):
â–ª When recording in Detect mode:
â—¦ The recording will start as soon as the input signal exceeds the THRESHOLD value.
Until then the F1 button flashes and a WAITING FOR INPUT… message appears at
the bottom of the display. During this waiting phase you can also start the recording
manually by pressing F1 or cancel the recording by pressing F2 (CANCEL).
â—¦ Once the recording has started, press F1 (STOP) to stop the recording (it stops imme-
diately) or F2 (CANCEL) to cancel the recording (the recorded audio will not be
saved).
â–ª When recording in Sync mode:
â—¦ The recording will start at the next bar. Until then the F1 button flashes and a WAIT-
ING FOR NEXT BAR… message appears at the bottom of the display.
â—¦ Once the recording has started, the audio is recorded for the duration set by the
LENGTH control (see section ↑17.2.2, Selecting the Source and the Recording Mode
above). You can also press F1 (STOP) beforehand to stop the recording at the next
bar, or F2 (CANCEL) to cancel the recording (in that case the recorded audio will not
be saved).
Sampling and Sample Mapping
Recording Audio
MASCHINE MIKRO - Manual - 829
To Next Page
Loading...
Need help?
General
Weight and Dimensions
