Following parameters are available:
Parameter Description
TIME Section
MODE Here you can select either SPLIT, GRID, DETECT or MANUAL:
Split mode: The Sample will be sliced into equally spread Slices.
Grid mode: The Sample will be sliced according to note values.
Detect mode: The Sample will be sliced according to its transients.
Manual mode: You can manually slice the Sample as you see fit.
SLICES (Split and
Grid mode only)
When MODE is set to SPLIT (see above), SLICES lets you choose the
amount of Slices: 4, 8, 16 or 32.
When MODE is set to GRID (see above), SLICES lets you choose the
length of the Slices in note values: 4th, 8th,16th or 32nd notes.
SENSITIVITY (Detect
mode only)
When MODE is set to DETECT (see above), SENSITIVITY lets you
adjust the sensitivity of the transient detection. Higher values will
cause more Slices to be detected because more transients will be
recognized, lower values will result in less Slices. This parameter
should be adjusted until all the musically significant slices are being
detected in the waveform.
BPM (BPM Mode) Selects how the tempo is defined: If you select AUTO, MASCHINE
will calculate the tempo automatically. If you select MANUAL, you
can enter the tempo in BPM manually.
ADJUST If BPM is set to AUTO, you can choose between the tempo that
MASCHINE detected, or half or double of that tempo. If BPM is set
to MANUAL, you can adjust the tempo manually.
When MODE is set to DETECT, a second section of parameters is available at the bottom of the
display: the ENGINE section.
â–º When MODE is set to DETECT, press NAV + the Right Arrow button to show the ENGINE
section.
Sampling and Sample Mapping
Slicing a Sample
MASCHINE MIKRO - Manual - 855
To Next Page
Loading...
Need help?
General
Weight and Dimensions
