NEC Xen Topaz - Holding; Transferring Calls; Placing a Call on Hold; Retrieving a Held Call; Placing a Call on Exclusive Hold; Transferring a Call to another Extension

Xen Topaz Programming Manual 3
Introduction to Programming
Before you Start Programming
Location of Controls
One of the following Display Key Telephone is required for the Programming.
• 6TXD Key Telephone
• 12TXD Key Telephone
Alphanumeric Display Indicator
DC (Dial Control) Key
LND (Last Number Dial) Key
Programmable Function Keys
CHECK Key
CLEAR Key
OPAC (Operation Access) Key
CALL Key
FLASH Key
TRFR (Transfer) Key
DND/CONF Key
HOLD Key
MIC (Microphone) Key
VOL (Volume Control) Key
Microphone
Dial Keys
Handset
Speaker
SPK (Speaker) Key