NEC Xen Topaz - Program 21 - Outgoing Call Setup; Trunk Group Routing for Trunks

Program 21 to 25
Xen Topaz Programming Manual 154
PROGRAM 21: OUTGOING CALL SETUP
21-03: T
RUNK GROUP ROUTING FOR TRUNKS
Description
Use Program 21-03 : Trunk Group Routing for Trunks to set the Trunk Route Table for Automatic Exter-
nal Call Forward. The Route Table is set in Program 14-06.
Input Data
Conditions
None
Feature Cross Reference
♦ Trunk Group Routing
Telephone Programming Instructions
To enter data for Program 21-03 (Trunk Group Routing for Trunks):
1. Enter the programming mode.
2. Enter 21 03
3. Enter the number of the item you want to program.
4. Select the Trunk number to be programmed by pressing the FLASH or the VOLUME▲ or VOLUME▼
keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
IN
SA
SB
COPY
Trunk Port Number 1-51
Day/ Night Mode
Route table number Default Related Program
1-8 0-25 ( 0 : No setting) 0
14-06
14-01-07
21-03-01 Trunk1
Mode1=RouteTBL0
21-03-xx Trunkxx
xxxxx