NEC Xen Topaz - System Options for Single Line Telephones

Program 16 to 20
Xen Topaz Programming Manual 117
PROGRAM 20: SYSTEM OPTION SETUP
20-03: S
YSTEM OPTIONS FOR SINGLE LINE TELEPHONES
Description
Use Program 20-03 : System Options for Single Line Telephones to set up various options for Single
Line Telephones.
Input Data
Conditions
None
IN
SA
SB
Prog.
No.
Item Input Data Description Default
Related
Program
20-03-01
SLT Call Waiting
Answer Mode
0 : Hook Flash
1 : Hook Flash +
Service code
(894)
For a busy Single Line
Telephone, set the mode
used to answer a
camped-on trunk call.
0 11-12-47
20-03-02
-Not Used-
- -
20-03-03
SLT DTMF Dial to
Trunk Lines
0 : Receive all
dialled data, be-
fore sending
1 : Direct
through out
Type 0 : The system
keeps the digits dialled by
the SLT on a trunk in a
buffer. After all the digits
have been received, the
system sends all the dig-
its to the trunk. If the time
space between digits is
longer than the timer in
Item 4, the system
considers all digits re-
ceived.
Type 1 : The system
passes the received dial
from the SLT to the trunk
immediately. If the SLT
has a Last Number Dial
key without a pause, this
key may not be able to
use the Last number
dialling key with the Type
1 setting.
When toll restrictions are
used on SLT ports, the
setting must be Type 0.
0 20-03-04
20-03-04
Trunk Call Dial
Sending Time by
SLT
0-64800(sec.)
3
20-03-05
SLT Operation
Mode
0 : Normal Mode
1 : Extended
Mode1
2 : Extended
Mode2
0
20-03-06
Headset Ringing
Cancel Time
0-64800(sec.)
5