NEC Xen Topaz - Program 92: Copy Program; IRG Assignment for Normal Ring Trunk

Program 40 to 92
Xen Topaz Programming Manual 332
PROGRAM 92: COPY PROGRAM
92-01: Copy Command
Description
Use Program 92-01 : Copy Program to copy the data for one program to another keyset, port, group, etc.
Refer to the following charts to see which programs which can be copied.
Input Data
Note) Copy Program is applicable only for the following programs.
1. Trunk Port Base
IN
SA
SB
Program Number
xx-xx
Prog. No. Item Input Data
92-01-01
Source Number
Enter the extension, trunk, group, etc..
from which the data will be copied.
• In case of Trunk Base ….
Trunk Port Number 1-51
• In case of Trunk Group Base….
Trunk Group Number 1-25
• In case of Extension Base….
Extension Number (Up to 4 digits)
• In case of Department Group Base….
Department Group Number 1-32
• In case of DSS….
DSS Console Number 1-9
92-01-02
Destination Number (From)
Enter the first extension, trunk, group, etc.
number to which the information is to be
copied.
92-01-03
Destination Number (To)
Enter the last extension, trunk, group, etc.
number to which the information is to be
copied. If the information is only be cop-
ied to one extension, trunk, group, etc.,
enter the information entered in the Desti-
nation Number (From) entry.
Prog. No. Program Name Note
14-01
Trunk Basic Data Setup Copy all data except Trunk Name (14-01-01)
14-02
Analogue Trunk Data Setup
14-04
Behind PBX Setup
14-08
Music on Hold Source for Trunks
14-09
Conversation Recording Destination for
Trunk
21-03
Trunk Group Routing for Trunks
21-12
ISDN Calling Party Number Setup for
Trunk
22-02
Incoming Service Type Setup
22-03
Trunk Ring Tone Setup
22-05
IRG Assignment for Normal Ring Trunk
22-08
Second IRG Setup for unanswered DIL /
IRG
31-05
Incoming Ring Tone Audible on External
Speaker