NEC Xen Topaz - Dial Analysis Table for ARS;F-Route

Program 40 to 92
Xen Topaz Programming Manual 275
PROGRAM 44: ARS/F-ROUTE SETUP
44-02: S
YSTEM OPTIONS FOR ARS/F-ROUTE
Description
Use Program 44-02 : Dial Analysis Table for ARS/F-Route Access to set the Pre-Transaction Table for
selecting ARS/F-Route.
• Service Type 1 (Extension number)
The number goes to an extension after deleting the front digit(s).
Additional data
Assign the digit(s) to be deleted on top of the number for extension number usage. There must be at least
one digit deleted.
• Service Type 2 (ARS/F-Route select)
The number is controlled by ARS/F-Route table.
Additional data
Assign the ARS/F-Route table number for Program 44-05. (If the ARS/F-Route Time schedule is not used.)
Assign the ARS/F-Route selection number for Program 44-04. (If the ARS/F-Route Time schedule is used.)
• Service Type 3 (Dial Extension Analyze Table select)
The total length of the number exceeds more than 5 digits.
Additional data
Assign the referring Dial Extension Analyze Table number for Program 44-03.
Input Data
IN
SA
SB
Dial Analysis Number 1-120
Prog. No. Item Input Data Default
Related
Program
44-02-01
Dial Up to 4 digits
No setting
44-02-02
Service Type 0 : No setting
1 : Select Extension Call
2 : Select ARS/F-Route Access
3 : Select “Dial Extension Analyze Table”
0
44-02-03
Additional Data
• When Select 1 (Select Extension Call)
from 44-02-02 : 0-255 (Delete Digit)
(255 : delete all digit)
0
44-01
44-02-02
• When Select 2 (Select ARS/F-Route
Access) from 44-02-02 :
- Not Used F-Route Time Schedule
[Program 44-01 : 0]
0-500 (ARS/F-Route table Number)
(0 : No setting)
<Refer to Program 44-05>
- Used F-Route Time Schedule
[Program 44-01 : 1]
0-500 (ARS/F-Route select table Num-
ber) (0 : No setting)
<Refer to Program 44-04>
• When Select 3 (Select “Dial Extension
Analyze Table”) from 44-02-02 :
0-4 (Dial Extension Analyze Table
Number) (0 : No setting)
<Refer to Program 44-03>
44-02-04
Dial Tone Simulation 0 : Off
1 : On
0