NEC Xen Topaz - Single Line Telephone Basic Data Setup

Program 12 to 15
Xen Topaz Programming Manual 91
PROGRAM 15: EXTENSION BASIC SETUP
15-03: S
INGLE LINE TELEPHONE BASIC DATA SETUP
Description
Use Program 15-03 : Single Line Telephone Basic Data Setup to set up various Single Line Telephone
options.
Input Data
IN
SA
SB COPY
Extension Number Max.4 digits
Prog. No. Item Input data Default Related Program
15-03-01
-Not Used-
-
-
15-03-02
-Not Used-
-
-
15-03-03
Terminal Type
Enter 1 for this option to allow a sin-
gle line port to receive DTMF tones
after the initial call setup. Enter 0 to
have the port ignore DTMF tones
after the initial call setup. For Voice
Mail, always enter 1 (e.g., receive
DTMF tones).
0 : Normal
1 : Special
0
15-03-04
Flashing
Enables/disables Flash (Hold) for
single line telephones.
0 : Disable
1 : Enable
1
15-03-05
-Not Used-
-
-
15-03-06
-Not Used-
-
-
15-03-07
Enabled on hook when holding
and press Service code (SLT)
0 : Disable
1 : Enable
1 11-12-45
15-03-08
Answer on hook when holding
(SLT)
0 : Disable
1 : Enable
1 11-12-46
15-03-09
Extension Number Display
0 : Disable
1 : Enable
0
15-03-10
Caller Name Display
0 : Disable
1 : Enable
1 15-03-09
15-03-11
Caller-ID Type for External Module
FSK(0) or DTMF(1) the Caller ID sig-
nal for an external Caller ID module.
Important: If voice mail is used, this
setting must be disabled or the sys-
tem integration codes for disconnect
will be incorrect.
0 : FSK
1 : DTMF
0
15-03-12
Fixed Cadence
Select Normal Ring or Fixed
(1sOn/2sOff) Ring when incoming
call is being received.
0 : Normal
1 : Fixed
(1s On/2sOff)
0