NEC Xen Topaz - System Information Output

Program 40 to 92
Xen Topaz Programming Manual 323
PROGRAM 90: MAINTENANCE PROGRAM
90-13: S
YSTEM INFORMATION OUTPUT
Description
Use Program 90-13 : System Information Output to define the output port to be used as the system infor-
mation output. The baud rate for the COM port should be set in Program 10-21-02.
Input Data
Conditions
None
Feature Cross Reference
None
Telephone Programming Instructions
To enter data for Program 90-13 (System Information Output):
1. Enter the programming mode.
2. Enter 90 13
3. Enter the number of the item you want to program.
4. Enter data for the item you selected + HOLD.
5. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
IN
SA
SB
Prog. No. Item Input Data Default
90-13-01
Output Port Type
Indicate the type of connection used for the
SMDR.
0…No setting
1…COM Port (EXIFU)
0
90-13-02
-Not Used- - -
90-13-03
Dialling 1 from this program sends the system
report to the connected device.
Dial 1 and press HOLD
(Press only HOLD key for
cancel)
-
90-13-01
Output Type 0
90-13-xx
xxxxx