NEC Xen Topaz - System Options for Caller ID

Program 16 to 20
Xen Topaz Programming Manual 146
PROGRAM 20: SYSTEM OPTION SETUP
20-19: S
YSTEM OPTIONS FOR CALLER ID
Description
Use Program 20-19 : System Options for Caller ID to define the system options for the Caller ID feature.
Input Data
Conditions
None
Feature Cross Reference
♦ Distinctive Ringing, Tones, and Flash Patterns
Telephone Programming Instructions
To enter data for Program 20-19(System Options for Caller ID):
1. Enter the programming mode.
2. Enter 20 19
3. Enter the number of the item you want to program.
4. Enter data for the item you selected + HOLD.
5. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
IN
SA
SB
Prog. No. Item Input data Default
Related
Program
20-19-01
Caller ID Displaying Format if Displaying Digits
are more than 12 digits.
0 : First 10 digits
1 : Last 10 digits
0
20-19-02
Caller ID Wait Timer
When an incoming CO call is received, the sys-
tem starts the timer. It will wait the programmed
time for Caller ID information from telco before
connecting the CO call.
0-30(sec.) 2
14-02-10
20-19-03
Caller ID Edit Mode
Edit Caller ID Enables/disables an extension’s
ability to edit the stored Caller ID information
0 : Off
1 : On
1 14-02-10
15-07-01
15-02-15
20-09-02
20-09-04
10-02-03
20-19-04
Wait Facility IE Timer 0-64800(sec.) 10
20-19-05
Caller-ID Sender active Timer 0-64800(sec.) 0
20-19-06
Caller-ID Sender Guard Timer 0-64800(sec.) 0
20-19-01
CallerID Format0
20-19-xx
xxxxx