NEC Xen Topaz - Incoming Virtual Extension Ring Tone Setup

Program 12 to 15
Xen Topaz Programming Manual 100
PROGRAM 15: EXTENSION BASIC SETUP
15-08: I
NCOMING VIRTUAL EXTENSION RING TONE SETUP
Description
Use Program 15-08 : Incoming Virtual Extension Ring Tone Setup to assign a ring tone range (0-4) to
incoming virtual extensions assigned to a Virtual Extension key (Program 15-07). If you enable ringing for
the key in Program 15-09, the key rings with the tone you set in this program. Also see Program 22-03. The
chart below shows the available tones.
Input Data
Conditions
None.
Feature Cross Reference
♦ Multiple Directory Number/ Call Coverage
IN
SA
SB COPY
Extension Number Max. 4 digits
Incoming Ring Pattern Default Description
0 : Tone Pattern 1
1 : Tone Pattern 2
2 : Tone Pattern 3
3 : Tone Pattern 4
4 : Incoming Extension Ring
Tone
0 :
Tone Pattern
1
When an extension or a virtual extension is assigned to
the function key on the key telephone, select the ring
tone when receiving a call on that key.
Incoming Signal Frequency Pattern Frequency Modulation
0: Tone Pattern 1 600/450/16Hz FM
1: Tone Pattern 2 450/16Hz AM
2: Tone Pattern 3 600Hz
-
3: Tone Pattern 4 600/450/16Hz FM
4: Internal Incoming Signal Frequency