NEC Xen Topaz - Class of Service Options (Outgoing Call Service)

Program 16 to 20
Xen Topaz Programming Manual 123
PROGRAM 20: SYSTEM OPTION SETUP
20-08: C
LASS OF SERVICE OPTIONS (OUTGOING CALL SERVICE)
Description
Use Program 20-08 : Class of Service Options (Outgoing Call Service) to define the Outgoing call fea-
ture availability for each extension’s Class of Service.
Input Data
IN
SA
SB
Class of Service Number 01-15
Prog. No. Item Input Data Default*
Related
Program
20-08-01
Intercom Calls
Enable/disable Intercom calling for the extension.
0 : Off
1 : On
1
20-08-02
Trunk Calls
Enable/disable outgoing trunk calling for the extension.
1
20-08-03 Common Abbreviated Dialling
1
20-08-04 Group Abbreviated Dialling
1
20-08-05
Dial Number Preview
Enable/disable an extension’s ability to use Dial Number
Preview.
1
20-08-06
Toll Restriction Override
Enables/disables Toll Restricting Override (Service Code
875).
1
21-01-07
21-07
20-08-07
Repeat Redial
Enables/disables an extension’s ability to use Repeat
Redial.
1
20-08-08
Toll Restriction Dial Block
Enable (1) or disable (0) an extension’s ability to use Dial
Block.
0
20-08-09
Hotline/Extension Ringdown
Enables/disables Ringdown Extension for extensions
with this COS.
0
20-08-10
Switching from Handsfree Answerback to Forced
Intercom Ringing
Enables/disables an extension’s ability to force Handsfree
Answerback or Forced Intercom Ringing for outgoing
Intercom calls.
1
20-08-11
Protect for the call mode switching from caller
(Internal Call)
0
20-08-12
Department Group Step Calling
Enables/disables an extension’s ability to use Department
Group Step Calling
1
20-08-13
CLIP
Set calling Party Number
1 10-03-05
20-08-14 Call Sub-Address Information
0