NEC Xen Topaz - Page 131

Program 16 to 20
Xen Topaz Programming Manual 124
PROGRAM 20: SYSTEM OPTION SETUP
20-08: C
LASS OF SERVICE OPTIONS (OUTGOING CALL SERVICE)
Input Data (Cont)
*All Classes are above mentioned default value.
Conditions
None
Feature Cross Reference
♦ Class of Service
Telephone Programming Instructions
To enter data for Program 20-08(Class of Service Options (Outgoing Call Service)):
1. Enter the programming mode.
2. Enter 20 08
3. Enter the number of the item you want to program.
4. Select the Class of Service number to be programmed by pressing the FLASH or the VOLUME
▲ or
VOLUME▼ keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
IN
SA
SB
Prog. No. Item Input Data Default*
Related
Program
20-08-15
Block Outgoing Caller ID
Enable (1) or disable (0) the system’s ability to automati-
cally block outgoing Caller ID information when a user
places a call. If this option is on, the system automatically
inserts the Caller ID block code (defined in Program 14-
01-21) before the user’s dialled digits.
0 : Off
1 : On 0
14-01-20
14-01-21
20-08-16
-Not Used-
- - -
20-08-17 ARS Override Access Map
0 : Disable
(Not Override)
1 : Enable
（Override)
0
20-08-01 F-Cls1
Intercom Call 1
20-08-xx F-Clsxx
xxxxx