Program 21 to 25
Xen Topaz Programming Manual 173
PROGRAM 22: INCOMING CALL SETUP
22-03: T
RUNK RING TONE SETUP
Description
Use Program 22-03 : Trunk Ring Tone Setup to select the ring tone range for the trunk. The trunk uses a
ring tone within the range selected when it rings an extension. There are three ring tones available.
Input Data
Conditions
None
Feature Cross Reference
♦ Selectable Ring Tones
Telephone Programming Instructions
To enter data for Program 22-03(Trunk Ring Tone Setup):
1. Enter the programming mode.
2. Enter 22 03
3. Enter the number of the item you want to program.
4. Select the trunk number to be programmed by pressing the FLASH or the VOLUME
▲ or VOLUME ▼
keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
IN
SA
SB COPY
Trunk Port Number
1-51
Ring Tone Pattern Default Description
Related
Program
0-2
（Ring Tone pattern 1-3）
0
Use this program to select the ring tone
range for the trunk. The trunk uses a ring
tone within the range selected when it
rings an extension. There are three ring
tones available.
15-02
Incoming Signal Frequency Pattern Frequency Modulation
0: Tone Pattern 1 600/450/16Hz FM
1: Tone Pattern 2 450/16Hz AM
2: Tone Pattern 3 600Hz
22-03-01 Trunk1
Ring Tone Pat 0
22-03-xx Trunkxx
xxxxx
To Next Page
Loading...
