NEC Xen Topaz - DID;DISA Error Message Assignment

Program 21 to 25
Xen Topaz Programming Manual 209
PROGRAM 25: DID/DISA SETUP
25-05: DID/DISA E
RROR MESSAGE ASSIGNMENT
Description
Use Program 25-05 : DID/DISA Error Message Assignment to assign the VRS message number to be
used as the Automated Attendant error message. For each DID/DISA trunk that the VRS will answer, enter
the VRS message (1-48) the outside caller hears if they dial incorrectly. If you enter 0 (i.e., no error mes-
sage), the call reroutes according to Program 25-03 and 25-04.
For each trunk, you make a separate entry for each Night Service mode.
Input Data
Conditions
None
Feature Cross Reference
♦ Direct Inward System Access (DISA)
Telephone Programming Instructions
To enter data for Program 25-05 (DID/DISA Error Message Assignment):
1. Enter the programming mode.
2. Enter 25 05
3. Enter the number of the item you want to program.
4. Select the Trunk port number to be programmed by pressing the FLASH or the VOLUME▲ or
VOLUME▼ keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
IN
SA
SB
Trunk Port Number
1-51
Day/Night
Mode
VRS Message Number Default Related Program
1-8
0-48 (0 : No setting) 0
25-05-01TrkPrt1
Mode1 MSG No=0
25-05-xxTrkPrtxx
xxxxx