NEC Xen Topaz - LAN Setup for External Equipment

Xen Topaz Programming Manual 26
Program 10 to 11
PROGRAM 10: SYSTEM CONFIGURATION SETUP
10:20 LAN S
ETUP FOR EXTERNAL EQUIPMENT
Description
Use Program 10-20 : LAN Setup for External Equipment to define the TCP port/address/etc. for commu-
nicating to external equipment.
Input Data
Conditions
None
Feature Cross Reference
None
Telephone Programming Instructions
To enter data for Program 10-20 (LAN Setup for External Equipment):
1. Enter the programming mode.
2. Enter 10 20
3. Enter the number of the item you want to program.
4. Select the External Device number to be programmed by pressing the FLASH or the VOLUME ▲ or
VOLUME ▼ keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section
IN
SA
SB
Type of External Equipment
5 : SMDR Output
Prog. No. Item Input data Default
10-20-01 TCP Port 0-65535 0
10-20-02 -Not Used- - -
10-20-03 Keep alive time 1-255(sec) 30
10-20-01 Ex-Dev1
TCP Port
10-20-xx Ex-Devx
xxxxx