NEC Xen Topaz - Trunk Group Routing for DISA

Program 21 to 25
Xen Topaz Programming Manual 216
PROGRAM 25: DID/DISA SETUP
25-10: T
RUNK GROUP ROUTING FOR DISA
Description
Use Program 25-10 : Trunk Group Routing for DISA to assign the Trunk Group route chosen when a
user places a DISA call into the system and dials 9. Set Trunk Group Routing in Program 14-06. Enable or
disable the DISA caller’s ability to dial 9 in Program 20-14-02. You assign a route to each DISA Class of
Service (1-15). The system assigns a DISA Class of Service to a call based on the password the DISA
caller dials.
When programming, you make a separate entry for each Night Service Mode.
Input Data
Conditions
None
Feature Cross Reference
♦ Direct Inward System Access (DISA)
Telephone Programming Instructions
To enter data for Program 25-10(Trunk Group Routing for DISA):
1. Enter the programming mode.
2. Enter 25 10
3. Enter the number of the item you want to program.
4. Select the DISA User number to be programmed by pressing the FLASH or the VOLUME▲ or
VOLUME▼ keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
IN
SA
SB
DISA User Number
1-15
Day/Night Mode Route Table Number Default
1-8 0-25 (0 : No Setting) 1
25-10-01DISA-U1
Mode1 RouteTbl1
25-10-xxDISA-Uxx
xxxxx