NEC Xen Topaz - Program 14 - Basic Trunk Data; Analogue Trunk Data Setup

Program 12 to 15
Xen Topaz Programming Manual 76
Input Data (Cont’d)
Conditions
None
Feature Cross Reference
♦ None
Telephone Programming Instructions
To enter data for Program 14-02(Analogue Trunk Data Setup):
1. Enter the programming mode.
2. Enter 14 02
3. Enter the number of the item you want to program.
4. Select the Trunk port number to programmed by pressing the FLASH or the VOLUME▲ or VOLUME▼
keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
Prog. No. Item Input data Default
Related
Program
14-02-09
Busy Tone Detection
Detects disconnect status of Trunk to Trunk
Transfer
0 : Disable
1 : Enable
0
14-02-10
Caller-ID
Enable or Disable a trunk’s ability to receive
Caller ID information
0 : Disable
1 : Enable
0
14-02-11
Not Used
-
-
14-02-12
Detect Network Disconnect Signal
0 : Disable
1 : Enable
0 14-02-05
14-02-11
14-02-13
Trunk-to-Trunk Limitation
0 : Disable
1 : Enable
0 14-02-12
24-02-07
14-02-14
Loop Start/Ground Start
0 : Loop Start
1 : Ground Start
0
14-02-15
-Not Used- -
-
-
14-02-16
Caller-ID Type for Analogue Trunk
0 : FSK
1 : DTMF
0
14-02-01 Trunk1
DP/DTMF 1
14-02-xx Trunkxx
xxxxx