NEC Xen Topaz - DID Translation Number Conversion

Program 21 to 25
Xen Topaz Programming Manual 183
PROGRAM 22: INCOMING CALL SETUP
22-11: DID T
RANSLATION NUMBER CONVERSION
Description
Use Program 22-11 : DID Translation Number Conversion to specify for each Translation Table entry
(2000):
• The digits received by the system (eight max.)
• The extension the system dials after translation (36 digits max.)
• The name that should show on the dialled extension’s display when it rings (twelve characters max.)
• The Transfer Target-1 and 2
If the Transfer Targets are busy or receive no answer, those calls are transferred to the final transfer desti-
nation (Program 22-10).
• Operation mode
Use the following chart when entering and editing text for names. Press the key once for the first character,
twice for the second character, etc. For example, to enter a C, press “2” three times.
IN
SA
SB
Key
Number of Key Presses
1 2 3 4 5 6 7 8 9 10 11 12 13
1 1 @ [ \ ] ^ _ ` { | }
2 A B C a b c 2
3 D E F d e f 3
4 G H I g h i 4
5 J K L j k l 5
6 M N O m n o 6
7 P Q R S p q r s 7
8 T U V t u
v 8
9 W X Y Z w x y z 9
0 0 ! “ # $ % & ’ ( )
#
* * + , - . / : ; < = > ?
LND
Move the cursor to the left
OPAC
Move the cursor to the right
CONF
Clear the character entry to the left, one character at a time (Backspace Key)
CLEAR
Clear all the entries from the point of the flashing cursor and to the right.
FLASH
Switch the cursor moves to the upper row of the display and pressing FLASH again to moves the
cursor back to the lower row.
-Not Used-