Program 21 to 25
Xen Topaz Programming Manual 208
PROGRAM 25: DID/DISA SETUP
25-04: DID/DISA T
RANSFER RING GROUP WITH NO ANSWER/BUSY
Description
Use Program 25-04 : DID/DISA Transfer Ring Group with No Answer/Busy to set the operating mode of
each DISA trunk. This sets what happens to the call when the DISA caller calls a busy or unanswered ex-
tension. The call can either disconnect (0) or Transfer to an alternate destination (a ring group or voice
mail). When setting the DISA and DID Operating Mode, you make an entry for each Night Service mode.
Input Data
Conditions
None
Feature Cross Reference
♦ Direct Inward System Access (DISA)
Telephone Programming Instructions
To enter data for Program 25-04(DID/DISA Transfer Ring Group with No Answer/Busy):
1. Enter the programming mode.
2. Enter 25 04
3. Enter the number of the item you want to program.
4. Select the Trunk port number to be programmed by pressing the FLASH or the VOLUME▲ or
VOLUME▼ keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
IN
SA
SB
Trunk Port Number
1-51
Day/Night
Mode
Incoming Group Number Default Related Program
1-8
0 : Disconnect
1-25 : Incoming Ring Group
101 : (DSPDB-VM)
0 22-04
25-04-01TrkPrt1
Mode1 IRG No=0
25-04-xxTrkPrtxx
xxxxx
To Next Page
Loading...
