NEC Xen Topaz - Program 22 - Incoming Call Setup; Incoming Call Trunk Setup

Program 21 to 25
Xen Topaz Programming Manual 172
PROGRAM 22: INCOMING CALL SETUP
22-02: I
NCOMING CALL TRUNK SETUP
Description
Use Program 22-02 : Incoming Call Trunk Setup to assign the incoming trunk type for each trunk. There
is one item for each Night Service Mode.
Input Data
Conditions
None
Feature Cross Reference
♦ Central office Calls, Answering
Telephone Programming Instructions
To enter data for Program 22-02(Incoming Call Trunk Setup):
1. Enter the programming mode.
2. Enter 22 02
3. Enter the number of the item you want to program.
4. Select the trunk number to be programmed by pressing the FLASH or the VOLUME
▲ or VOLUME▼
keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
IN
SA
SB COPY
Trunk Port Number
1-51
Day/Night
Mode.
Incoming Type Default Description
Related
Program
1-8
0 : Normal
1 : VRS (Second Dial Tone if no
VRS installed)
2 : DISA
3 : DID (ISDN)
4 : DIL
5 : -Not Used-
6 : Delayed VRS/DISA
0 Use this option to set the fea-
ture type for the trunk you are
programming.
14-04
25-01
25-02
25-03
25-04
25-06
25-07
25-09
25-10
25-11
25-12
25-13
22-02-01 Trunk1
Mode1 TRK Type=0
22-02-xx Trunkxx
xxxxx