Program 26 to 35
Xen Topaz Programming Manual 247
PROGRAM 31: EXTERNAL SPEAKER AND INTERNAL PAGING
31-06: E
XTERNAL SPEAKER CONTROL
Description
Use Program 31-06 : External Speaker Control to define the settings for the external speaker using an
amplifier.
Input Data
Conditions
Speakers 1 ~ 6 apply to 2 PGDU card.
Speaker 7 is the in-built part on 308M.
Feature Cross Reference
♦ Paging, External
Telephone Programming Instructions
To enter data for Program 31-06 (External Speaker Control):
1. Enter the programming mode.
2. Enter 31 06
3. Enter the number of the item you want to program.
4. Select the External Speaker number to be Programmed by pressing the FLASH or the VOLUME▲ or VOLUME▼
keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
IN
SA
SB
Prog. No.
External
Speaker No.
Item Input Data
Default
31-06-01
1-7
Broadcast Splash Tone Before
Paging
Use this option to enabled or disable splash
tone before Paging over an external zone. If
enabled, the system broadcasts a splash
tone before the External Paging announce-
ment.
0 : No tone
1 : Splash tone
2 : Chime tone
2
31-06-02
Broadcast Splash Tone After Paging
Use this option to enabled or disable splash
tone after Paging over an external zone. If
enabled, the system broadcasts a splash
tone at the end of an External Paging an-
nouncement.
0 : No tone
1 : Splash tone
2 : Chime tone
2
31-06-03
Speech Path（2PGDU—Speaker）
0 : Both way
1 : One way
1
31-06-04
CODEC Transmit Gain Setup
1-63(-15.5……...+15.5) 32 (0dB)
31-06-05
CODEC Receive Gain Setup
1-63(-15.5……...+15.5) 32 (0dB)
31-06-01 SPK 1
PG Start Tone 2
31-06-xx
xxxxx
To Next Page
Loading...
