NEC Xen Topaz - Program 90 - Maintenance Program; Setting the Programming Password

Program 40 to 92
Xen Topaz Programming Manual 308
PROGRAM 90: MAINTENANCE PROGRAM
90-02: S
ETTING THE PROGRAMMING PASSWORD
Description
Use Program 90-02 : Setting the Programming Password to set the system passwords. For password
entry purposes, the system allows 8 users to be defined. Each user can have a:
• Unique alphanumeric name (up to 10 alphanumeric characters long.
• Password entry of up to 8 digits (using 0-9, # and *)
• Password level
The “IN” level password is used by the “System Installer” for system programming purposes. The “SA” or
“SB” level password cannot access the “IN” level programs. The reverse type (white on black) just beneath
the Description heading is the program’s access level. You can only use the program if your access level
meets or exceeds the level the program requires. (“SA” level password can access to “SA” or “SB” pro-
grams, and “SB” level password can access to “SB” programs only.)
!! Caution !!
It is NOT recommended to change this data unnecessarily. If the digits are changed and then forgotten,
there may be no normal way to enter the program mode again.
Input Data
Default
Conditions
Two extensions can be in the programming mode.
IN
SA
SB
User Number 1-8
Prog. No. Item Input Data
Related
Program
90-02-01
User Name Max. 10 characters
90-02-02
Password Up to 8 digits
90-02-03
User Level
0- Prohibited user
1- MF (Manufacturer level - for NEC-i use only)
2- IN (Installer level)
3- SA (System administrator level 1)
4- SB (System administrator level 2)
User No. User Name Password Level Level Description
1 NEC-I - 1 (MF)
Blocked User (Manufacturer
programming access only)
2 tech 12345678 2 (IN)
Installer Level - Access to all programs
this manual
3 ADMIN1 0000 3 (SA)
System Administrator Level 1 - Re-
stricted access
4 ADMIN2 9999 4 (SB)
System Administrator Level 2 - More
restricted access
5 -Not Used- -Not Used- -
6 -Not Used- -Not Used- -
7 -Not Used- -Not Used- -
8 -Not Used- -Not Used- -