Program 16 to 20
Xen Topaz Programming Manual 143
PROGRAM 20: SYSTEM OPTION SETUP
20-17: O
PERATOR’S EXTENSION
Description
Use Program 20-17 : Operator’s Extension to designate an operator. When an extension user dials “0” or
“9” (defined by Program 11-01 Type 5), calls go to the operator selected in this program.
If you don’t assign an extension in Program 90-11-01, system alarms appear on the extension assigned in
this option.
Input Data
Conditions
None
Feature Cross Reference
♦ Intercom
Telephone Programming Instructions
To enter data for Program 20-17(Operator’s Extension):
1. Enter the programming mode.
2. Enter 20 17
3. Enter the number of the item you want to program.
4. Select the Operator number to be programmed by pressing the FLASH or the VOLUME
▲ or
VOLUME▼ keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
IN
SA
SB
Operator Number
1-8
Prog. No. Item Input Data Default
Related
Program
20-17-01 Operator Extension Number Max. 4 digits
200
11-01
20-17-02
Operator Console 0 : Normal KTS
1 : Special Operator Console
0
20-17-01 Operat1
Oper.Ext.No.
20-17-xxOperatx
xxxxx
To Next Page
Loading...
