NEC Xen Topaz - Dial Block Release

Program 40 to 92
Xen Topaz Programming Manual 326
PROGRAM 90: MAINTENANCE PROGRAM
90-19: D
IAL BLOCK RELEASE
Description
When the extension number is entered in Program 90-19 : Dial Block Release, the extension will be re-
leased from the Dial Block restriction.
Input Data
Conditions
None
Feature Cross Reference
♦ Toll Restriction
Telephone Programming Instructions
To enter data for Program 90-19 (Dial Block Release)
1. Enter the programming mode.
2. Enter 90 19
3. Enter the number of the item you want to program.
4. Select the Extension number to be programmed by pressing the FLASH or the VOLUME▲ or
VOLUME▼ keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
IN
SA
SB
Extension Number
Up to 4 digits
Input Data
[CLR Dial Block] : Dial 1 and press HOLD key
(Press only HOLD key for cancel)
90-19-01 TELxxx
CLR Dial Block
90-19-xx TELxxxx
xxxxx