NEC Xen Topaz - Trunk Access Map Setup; Trunk Access Map for Extensions

Program 12 to 15
Xen Topaz Programming Manual 93
PROGRAM 15: EXTENSION BASIC SETUP
15-06: T
RUNK ACCESS MAP FOR EXTENSIONS
Description
Use Program 15-06 : Trunk Access Map for Extensions to define the trunk access map for each exten-
sion. An extension can only place outgoing calls on trunks to which it has outgoing access. Use Program
14-07 to define the available 51 access maps.
Input Data
Conditions
None
Feature Cross Reference
♦ Central Office Calls, Answering
♦ Central Office Calls, Placing
Telephone Programming Instructions
To enter data for Program 15-06(Trunk Access Map for Extensions):
1. Enter the programming mode.
2. Enter 15 06
3. Enter the number of the item you want to program.
4. Select the Extension number to programmed by pressing the FLASH or the VOLUME▲ or VOLUME▼
keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
IN
SA
SB COPY
Extension Number Max. 4 digits
Day/Night Mode
Trunk Access Map No. Default Related Program
1-8 1-51 1 14-07
15-06-01 TEL200
Mode1 Acc-Map1
15-06-xx TELxxxx
xxxxx