NEC Xen Topaz - Program 26 - ARS Service & Least Cost Routing; ARS Dial Treatment

Program 26 to 35
Xen Topaz Programming Manual 225
PROGRAM 26: ARS SERVICE & LEAST COST ROUTING
26-03: ARS D
IAL TREATMENT
Description
Use Program 26-03 : ARS Dial Treatments to assign the 15 Dial Treatments for automatic ARS Dialling
translation. Assign Dial Treatments to Service Numbers (Trunk Groups) in Program 26-02.
The ARS Dial Treatment options are:
• 3 - Delete the NPA if dialled as part of the initial call.
• 2 - Delete the leading digit if dialled as part of the initial call.
• 1 - Add a leading 1 if not dialled as part of the initial call.
• INPA - Insert the NPA specified by NPA.
• DNN - Outdial the NN number of digits or execute the code that follows. For example, D041234 out-dials
1234. Valid entries are 0-9, #, *, Wnn (wait nn seconds) and P (pause). Each digits code counts as a digit.
So for example, if a P was added for a pause, the entry would look like: D05P1234. This Dial Treatment can
only be added from telephone programming.
• Wnn - Wait nn seconds.
• P - Pause in analogue trunk.
• R - Redial the initially dialled number, including any modifications
• E - End of Dial Treatment. All Dial Treatments must end with the E code.
Input Data
Conditions
None
Feature Cross Reference
♦ Automatic Route Selection
Telephone Programming Instructions
To enter data for Program 26-03(ARS Dial Treatments):
1. Enter the programming mode.
2. Enter 26 03
3. Enter the number of the item you want to program.
4. Select the Dial Treatment Table number to be programmed by pressing the FLASH or the VOLUME▲ or
VOLUME▼ keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section
IN
SA
SB
Prog. No.
Dial Treatment
Table Number
Input Data Default
Related
Program
26-03-01
1-15
Max. 36 characters
No setting
26-02
26-03-01ARS-T1
26-03-xxARS-Txx
xxxxx