NEC Xen Topaz - 90-08 SYSTEM Reset

Program 40 to 92
Xen Topaz Programming Manual 315
PROGRAM 90: MAINTENANCE PROGRAM
90-08: S
YSTEM RESET
Description
Use Program 90-08 : System Reset is used to perform a system reset.
Input Data
[System-Reset] : Dial 1 and HOLD key (Press only HOLD key for cancel)
Conditions
None
Feature Cross Reference
None
Telephone Programming Instructions
To enter data for Program 90-08 (System Reset):
1. Enter the programming mode.
2. Enter 90 08
3. Enter the number of the item you want to program.
4. Enter data for the item you selected + HOLD.
5. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
IN
SA
SB
90-08-01
SYS-Reset 1
90-08-xx
xxxxx