Program 40 to 92
Xen Topaz Programming Manual 331
PROGRAM 90: MAINTENANCE PROGRAM
90-26: System Data Programming Level Setup
Description
Use Program 90-26 : System Data Programming Level Setup to define the programming access level of
each command.
Input Data
Conditions
You can only set a level equal or lower than the level you are logged on. e.g. if you log on as installer you
can not set any to manufacturer level.
Feature Cross Reference
None
Telephone Programming Instructions
To enter data for Program 90-26 (System Data Programming Level Assignment):
1. Enter the programming mode.
2. Enter 90 26
3. Enter the number of the item you want to program.
4. Select the Program number to be programmed by pressing the FLASH or the VOLUME▲ or VOLUME▼
keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
IN
SA
SB
Program Number
1001-9201
Prog. No. Item Input Data Default
90-26-01
Maintenance Level
1 : MF (Manufacturing Level)
2 : IN (Installer Level)
3 : SA (System Administrator A)
4 : SB (System Administrator B)
Refer to each
header of Program-
ming Manual
90-26-01 PRG1001
Maintenance LVL3
90-26-xx PRGxxxx
xxxxx
To Next Page
Loading...
