NEC Xen Topaz - System Alarm Output

Program 40 to 92
Xen Topaz Programming Manual 322
PROGRAM 90: MAINTENANCE PROGRAM
90-12: S
YSTEM ALARM OUTPUT
Description
Use Program 90-12 : System Alarm Output to set the options for the alarm report. This program has 6
separate menu options. Define the output port to be used as the output for system alarm report and set the
system alarm options. The system can have up to 50 reports.
Input Data
Conditions
None
Feature Cross Reference
None
Telephone Programming Instructions
To enter data for Program 90-12 (System Alarm Output):
1. Enter the programming mode.
2. Enter 90 12
3. Enter the number of the item you want to program.
4. Enter data for the item you selected + HOLD.
5. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
IN
SA
SB
Prog. No. Item Input Data Default
90-12-01
Output Port Type
Indicate the type of connection used for the
System Alarms. The baud rate for the COM
port should be set in Program 10-21-02.
0 : No setting
1 : COM Port (EXIFU)
0
90-12-02
-Not Used- - -
90-12-03
Output All Alarm Reports
Print All? (Yes : 1)
-
90-12-04
Printout New Alarm Reports
Print New? (Yes: 1)
-
90-12-05
Clear All Alarm Reports
All Clear? (Yes : 1)
-
90-12-06 Output Mode
0 : Manual
1 : Auto
0
90-12-01
Output Type 0
90-12-xx
xxxxx