NEC Xen Topaz - Traffic Report Data Setup

Program 40 to 92
Xen Topaz Programming Manual 327
PROGRAM 90: MAINTENANCE PROGRAM
90-20: Traffic Report Data Setup
Description
Use Program 90-20 : Traffic Report Data Setup to define the details of the traffic report.
Input Data
Conditions
None
Feature Cross Reference
♦ Traffic Management Reporting (TMS)
Telephone Programming Instructions
To enter data for Program 90-20 (Traffic Report Data Setup):
1. Enter the programming mode.
2. Enter 90 20
3. Enter the number of the item you want to program.
4. Enter data for the item you selected + HOLD.
5. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
IN
SA
SB
Prog. No. Item Input Data Default
90-20-01
Call Traffic Output
0 : Not measured
1 : Measured
0
90-20-02
-Not Used- - -
90-20-03
All Line Busy Output
0 : Not detected
1-256 : (Report when the
data is reached to the
defined value)
-
0
90-20-04
DTMF Receiver Busy Output 0
90-20-05
Dial Tone Detector Busy Output 0
90-20-06
Caller-ID Receiver Busy Output 0
90-20-07
Voice Mail Channel All Busy Output 0
90-20-08
-Not Used- -
90-20-09
Attendant Channel All Busy Output 0
90-20-10
Base Station All Busy Output 0
90-20-01
Call Traffic 0
90-20-xx
xxxxx