NEC Xen Topaz - DID Trunk Group to Translation Table Assignment

Program 21 to 25
Xen Topaz Programming Manual 187
PROGRAM 22: INCOMING CALL SETUP
22-13: DID T
RUNK GROUP TO TRANSLATION TABLE ASSIGNMENT
Description
Use Program 22-13 : DID Trunk Group to Translation Table Assignment to assign the DID Trunk
Groups to DID Translation Tables. DID trunks should be in their own group. If you have more than one type
of DID trunk, put each type in a separate Trunk Group. For each Trunk Group, you make a Translation Ta-
ble entry for each Night Service mode.
Input Data
Conditions
None
Feature Cross Reference
♦ Direct Inward Dialling (DID)
Telephone Programming Instructions
To enter data for Program 22-13 (DID Trunk Group to Translation Table Assignment):
1. Enter the programming mode.
2. Enter 22 13
3. Enter the number of the item you want to program.
4. Select the Trunk Group number to be programmed by pressing the FLASH or the VOLUME
▲ or
▼ VOLUME keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
IN
SA
SB
Trunk Group Number
1-25
Day/Night
Mode
Conversion Table Area Number
Default Related Program
1-8
0-20 (0 : No setting) 1
22-13-01TrkGrp1
Mode1 = 1
22-13-xxTrkGrpxx
xxxxx